'APURVA' sampling loom has been developed from the latest sampling and control techniques. This new generation of sampling loom is equipped with fully comprehensive automation, keasier operations and a new appearance. It is higher in speed and has a reduced level of noise. New warp preparation units especially designed to work with this sampling loom are also being launched at the same time. This complements the automation in sampling with higher flexibility. 

1.Weaving Width:	10-20 inches
2.Speed:	45 ppm maximum (with reference to fabric width of 20 inches)
3.Weft Selector:	6 colours electronic weft selection device. Maximum up to 8 colors (Optional)
4.Fabric Take-up:	Electronically controlled. Weft density can be changed freely within the same weave
5.Warp let-off:	Positive electronically controlled. Constant warp tension could be maintained during weaving.
6.Shedding:	Computerized controlled. Maximum 20 head frames driven pneumatically by air cylinders (1st & 2nd head frames are for leno & selvedges)
7.Draw-in:	Head frames can be separated from the loom for heads and reeds draw-in
8.Warping:	Separate warp beam or manual warping could both be used
9.Weft Insertion:	Single rapier weft insertion. Speed could be controlled independently through the computer
10.Beat-up:	Computerized servo-motor controlled. Beat-up could be done in different positions
11.Weft Breaks:	Mechanical weft-break detection device. Loom stops when weft breaks
12.Warp Breaks:	Photo-electric warp-break detection device. Loom stops when weft breaks
13.Designing:	Built-in SEdit2 design and editing software. It could also be installed separately on other PC for design works
14.Air Consumption:	580L/min. Air pressure 6-9kgf/sq-cm
15.Power:	220V Single phase, 50-60Hz